NTN 5206 Double Row Angular Contact Bearing - 30 mm Bore, 62 mm OD, 0.9375 in Width, Open, Without Snap Ring, 25 ° Contact Angle

SKU: NTN 5206

$15.31

الشحن محسوبة عند السداد

متوفر في الوقت الحاضر!

NTN 5206

Double Row Angular Contact Bearing - 30 mm Bore, 62 mm OD, 0.9375 in Width, Open, Without Snap Ring, 25 ° Contact Angle


SPECIFICATIONS

Bore Diameter 30 mm
Outside Diameter 62 mm
Width 0.9375 in
Overall Width 23.800 mm, 0.9370 in
Contact Angle 25 °
Row Type & Fill Slot Double-Row Non-Fill Slot
Closure Type Open
Cage Type Pressed
Internal Clearance C0
Snap Ring Included Without Snap Ring
Bearing Material High Carbon Chrome Steel
Radial Dynamic Load Capacity 29600 N
Radial Static Load Capacity 21100 N
Cage Material Steel
Harmonization Code 8482.10.5028
Outer Ring Width 23.8 mm
Inner Ring Width 23.800 mm, 0.9370 in
Configuration Two
Maximum RPM (Grease) 7100 rpm
Maximum RPM 9500 rpm
Finish/Coating Uncoated
Precision Rating Class 0
Fillet Radius 1 mm
Series 52
Dynamic Load Capacity 6650 lbf
Static Load Capacity 4750 lbf
Weight 0.66 lbs
Manufacturer UPC Number 4547359536638







Angular Contact Ball Bearings




1. Design features and characteristics

1.1  Angular contact ball bearing

Angular contact ball bearings are non-separable bearings with a defined contact angle in the radial direction relative to the straight line that runs through the point where each ball makes contact with the inner and outer rings (see Fig. 1). Table 1 provides information on contact angles and their designated codes.

In addition to radial loads, angular contact ball bearings can accommodate single direction axial loads. Since an axial load is generated from a radial force, these bearings are generally used in pairs. Table 2 shows general angular contact ball bearing characteristics, Table 3 shows information on using duplex (side by side) angular contact ball bearings, and Table 4 shows information on multiple-row angular contact ball bearings.

For bearings with a contact angle of 15° and bearing tolerance JIS Class 5 or higher, see special catalog “Precision rolling bearings (CAT. No. 2260/E)”.

 

 

1.2  Four-point angular contact ball bearings


Four-point angular contact ball bearings have a contact angle of 30° and a split inner ring. As shown in Fig. 2, when the inner and outer rings receive a radial load, the ball contacts the inner and outer rings at four points. This construction enables a single bearing to accommodate axial loads from either direction, and when under a simple axial load or heavy axial load, the bearing relies on two contact points like ordinary bearings.


 

1.3  Double row angular contact ball bearings

The structure of double row angular contact ball bearings is designed by arranging two single row angular contact bearings back-to-back in duplex (DB) to form a single bearing with a contact angle of 25°.
These bearings are capable of accommodating radial loads, axial loads in either direction, and have a high capacity for moment loads.
As shown in Fig. 4, sealed and shielded type double row angular contact ball bearings are also available. Standard loads vary from those of open type bearings.