NTN 5307 Double Row Angular Contact Bearing - 35 mm Bore, 80 mm OD, 1.3750 in Width, Open, Without Snap Ring, 25 ° Contact Angle

SKU: NTN 5307

$27.41

الشحن محسوبة عند السداد

متوفر في الوقت الحاضر!

NTN 5307

Double Row Angular Contact Bearing - 35 mm Bore, 80 mm OD, 1.3750 in Width, Open, Without Snap Ring, 25 ° Contact Angle




SPECIFICATIONS

Bore Diameter 35 mm
Outside Diameter 80 mm
Width 1.3750 in
Overall Width 34.900 mm, 1.3740 in
Contact Angle 25 °
Row Type & Fill Slot Double-Row Non-Fill Slot
Closure Type Open
Cage Type Pressed
Internal Clearance C0
Snap Ring Included Without Snap Ring
Bearing Material High Carbon Chrome Steel
Radial Dynamic Load Capacity 51000 N
Radial Static Load Capacity 36000 N
Cage Material Steel
Harmonization Code 8482.10.5028
Outer Ring Width 34.9 mm
Inner Ring Width 34.900 mm, 1.3740 in
Configuration Two
Maximum RPM (Grease) 5600 rpm
Maximum RPM 7500 rpm
Finish/Coating Uncoated
Precision Rating Class 0
Fillet Radius 1.5 mm
Series 53
Dynamic Load Capacity 11500 lbf
Static Load Capacity 8100 lbf
Weight 1.68 lbs
Manufacturer UPC Number 4547359539356






Angular Contact Ball Bearings




1. Design features and characteristics

1.1  Angular contact ball bearing

Angular contact ball bearings are non-separable bearings with a defined contact angle in the radial direction relative to the straight line that runs through the point where each ball makes contact with the inner and outer rings (see Fig. 1). Table 1 provides information on contact angles and their designated codes.

In addition to radial loads, angular contact ball bearings can accommodate single direction axial loads. Since an axial load is generated from a radial force, these bearings are generally used in pairs. Table 2 shows general angular contact ball bearing characteristics, Table 3 shows information on using duplex (side by side) angular contact ball bearings, and Table 4 shows information on multiple-row angular contact ball bearings.

For bearings with a contact angle of 15° and bearing tolerance JIS Class 5 or higher, see special catalog “Precision rolling bearings (CAT. No. 2260/E)”.

 

 

1.2  Four-point angular contact ball bearings


Four-point angular contact ball bearings have a contact angle of 30° and a split inner ring. As shown in Fig. 2, when the inner and outer rings receive a radial load, the ball contacts the inner and outer rings at four points. This construction enables a single bearing to accommodate axial loads from either direction, and when under a simple axial load or heavy axial load, the bearing relies on two contact points like ordinary bearings.


 

1.3  Double row angular contact ball bearings

The structure of double row angular contact ball bearings is designed by arranging two single row angular contact bearings back-to-back in duplex (DB) to form a single bearing with a contact angle of 25°.
These bearings are capable of accommodating radial loads, axial loads in either direction, and have a high capacity for moment loads.
As shown in Fig. 4, sealed and shielded type double row angular contact ball bearings are also available. Standard loads vary from those of open type bearings.

 



 

No reviews