NTN 7324 Angular Contact Bearing - D=120

SKU: NTN 7324

$928.93

الشحن محسوبة عند السداد

متوفر في الوقت الحاضر!

NTN 7324

Single Angular Contact Ball Bearing - Open Type




SPECIFICATIONS

Bore Diameter 120 mm, 4.7244 in
Outside Diameter 260 mm, 10.2362 in
Overall Width 55 mm, 2.1654 in
Contact Angle 30 °
Closure Type Open
Cage Type High Strength, 2 piece, Machined
Bore Type Round
Bearing Material High Carbon Chrome Steel
Cage Material Brass
Harmonization Code 8482.10.5028
Outer Ring Width 2.1654 in; 55.000 mm
Inner Ring Width 55.000 mm, 2.1654 in
Configuration One
Maximum RPM (Grease) 2900 rpm
Maximum RPM 3900 rpm
Precision Rating ISO Class 0
Fillet Radius 0.1181 in, 3.000 mm
Dynamic Load Capacity 55500 lbf
Static Load Capacity 56500 lbf
Manufacturer UPC Number 4547359453911







Angular Contact Ball Bearings




1. Design features and characteristics

1.1  Angular contact ball bearing

Angular contact ball bearings are non-separable bearings with a defined contact angle in the radial direction relative to the straight line that runs through the point where each ball makes contact with the inner and outer rings (see Fig. 1). Table 1 provides information on contact angles and their designated codes.

In addition to radial loads, angular contact ball bearings can accommodate single direction axial loads. Since an axial load is generated from a radial force, these bearings are generally used in pairs. Table 2 shows general angular contact ball bearing characteristics, Table 3 shows information on using duplex (side by side) angular contact ball bearings, and Table 4 shows information on multiple-row angular contact ball bearings.

For bearings with a contact angle of 15° and bearing tolerance JIS Class 5 or higher, see special catalog “Precision rolling bearings (CAT. No. 2260/E)”.

 

 

1.2  Four-point angular contact ball bearings


Four-point angular contact ball bearings have a contact angle of 30° and a split inner ring. As shown in Fig. 2, when the inner and outer rings receive a radial load, the ball contacts the inner and outer rings at four points. This construction enables a single bearing to accommodate axial loads from either direction, and when under a simple axial load or heavy axial load, the bearing relies on two contact points like ordinary bearings.


 

1.3  Double row angular contact ball bearings

The structure of double row angular contact ball bearings is designed by arranging two single row angular contact bearings back-to-back in duplex (DB) to form a single bearing with a contact angle of 25°.
These bearings are capable of accommodating radial loads, axial loads in either direction, and have a high capacity for moment loads.
As shown in Fig. 4, sealed and shielded type double row angular contact ball bearings are also available. Standard loads vary from those of open type bearings.