NTN 7028 Angular Contact Bearing - D=140

SKU: NTN 7028


Shipping calculated at checkout

Available Now!

NTN 7028

Single Angular Contact Ball Bearing - Open Type


Bore Diameter 140 mm, 5.5118 in
Outside Diameter 210 mm, 8.2677 in
Overall Width 33 mm, 1.2992 in
Contact Angle 30 °
Closure Type Open
Cage Type High Strength, 2 piece, Machined
Bore Type Round
Bearing Material High Carbon Chrome Steel
Cage Material Brass
Harmonization Code 8482.10.5028
Outer Ring Width 1.2992 in; 33.000 mm
Inner Ring Width 33.000 mm, 1.2992 in
Configuration One
Maximum RPM (Grease) 3100 rpm
Maximum RPM 4100 rpm
Precision Rating ISO Class 0
Fillet Radius 2.000 mm, 0.0787 in
Dynamic Load Capacity 27000 lbf
Static Load Capacity 29900 lbf
Manufacturer UPC Number 4547359435542

Angular Contact Ball Bearings

1. Design features and characteristics

1.1  Angular contact ball bearing

Angular contact ball bearings are non-separable bearings with a defined contact angle in the radial direction relative to the straight line that runs through the point where each ball makes contact with the inner and outer rings (see Fig. 1). Table 1 provides information on contact angles and their designated codes.

In addition to radial loads, angular contact ball bearings can accommodate single direction axial loads. Since an axial load is generated from a radial force, these bearings are generally used in pairs. Table 2 shows general angular contact ball bearing characteristics, Table 3 shows information on using duplex (side by side) angular contact ball bearings, and Table 4 shows information on multiple-row angular contact ball bearings.

For bearings with a contact angle of 15° and bearing tolerance JIS Class 5 or higher, see special catalog “Precision rolling bearings (CAT. No. 2260/E)”.



1.2  Four-point angular contact ball bearings

Four-point angular contact ball bearings have a contact angle of 30° and a split inner ring. As shown in Fig. 2, when the inner and outer rings receive a radial load, the ball contacts the inner and outer rings at four points. This construction enables a single bearing to accommodate axial loads from either direction, and when under a simple axial load or heavy axial load, the bearing relies on two contact points like ordinary bearings.


1.3  Double row angular contact ball bearings

The structure of double row angular contact ball bearings is designed by arranging two single row angular contact bearings back-to-back in duplex (DB) to form a single bearing with a contact angle of 25°.
These bearings are capable of accommodating radial loads, axial loads in either direction, and have a high capacity for moment loads.
As shown in Fig. 4, sealed and shielded type double row angular contact ball bearings are also available. Standard loads vary from those of open type bearings.